21 NAND Docs 中文

Process ladder

The same Bard netlist, through place and route on seven process platforms. This page lists the area and frequency on each one.

The area, frequency and power on this page were computed by layout tools (OpenROAD-flow-scripts; LibreLane for SKY130) after a full flow run. They are not measured on a chip. The chip has not been made. Frequency is the result under a given timing constraint, not the limit.

Two words first

Summary table

PlatformCan it be taped outbody cell areabody frequencyFull-chip die areaFull-chip frequency
SKY130 (130 nm, baseline v8g)Yes, open-source process2.352 mm²About 8.6 MHz (ss corner, 200 ns clock, no setup-time optimization)15.09 mm² (full die, signed off)—
IHP SG13G2 (130 nm SiGe)Yes, open-source process6.83 mm²46.5 MHz22.09 mm²29.0 MHz
GF180MCU (180 nm)Yes, open-source process10.77 mm²15.7 MHz (5 V library)38.44 mm²7.07 MHz (3.3 V library)
ICsprout 55 nmWith conditions (see below)0.826 mm²117 MHz7.70 mm²From estimated parasitics, not extracted from the routed layout: 86.89 MHz
Nangate45 (45 nm predictive library)No0.526 mm²146 MHz5.53 mm²85.4 MHz
ASAP7 (7 nm predictive library)No0.0416 mm²294 MHz0.385 mm²110 MHz
GT2N (2 nm predictive library)No0.0207 mm²550 MHzFull chip not done—

Limits of ICsprout 55 nm

Function check

PlatformPost-route netlist replay L1 / L2 / L3
SKY130 v8gAll pass, cycle counts 2,499,420 / 5,612,207 / 9,418,594
IHP SG13G2All pass, cycle counts the same as SKY130 v8g
GF180MCUAll pass, cycle counts the same as SKY130 v8g
Nangate45, ASAP7Not replayed

Mask ROM area per bit

The three open-source processes you can tape out on use the same mask ROM structure. The SKY130 ROM is in the signed-off v8g full die. IHP SG13G2 and GF180MCU were redrawn, and all 60 banks have DRC 0 and match on LVS.

ProcessArea per bit (including precharge)
SKY1300.56 µm²
IHP SG13G20.46 µm²
GF180MCU0.85 µm²

Tools used

Next